home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Tech Arsenal 1
/
Tech Arsenal (Arsenal Computer).ISO
/
tek-05
/
drivers2.zip
/
NCRET105.ASM
< prev
next >
Wrap
Assembly Source File
|
1992-01-23
|
5KB
|
211 lines
version equ 0
include defs.asm
;Ported from Tim Krauskopf's micnet.asm, an assembly language
;driver for the MICOM-Interlan NI5210, by Russell Nelson. Any bugs
;are due to Russell Nelson.
;Updated to version 1.08 Feb. 17, 1989 by Russell Nelson.
;Updated to support 1500 byte MTU April 27, 1989 By Brad Clements.
; Copyright, 1988-1992, Russell Nelson, Crynwr Software
; This program is free software; you can redistribute it and/or modify
; it under the terms of the GNU General Public License as published by
; the Free Software Foundation, version 1.
;
; This program is distributed in the hope that it will be useful,
; but WITHOUT ANY WARRANTY; without even the implied warranty of
; MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
; GNU General Public License for more details.
;
; You should have received a copy of the GNU General Public License
; along with this program; if not, write to the Free Software
; Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA.
code segment word public
assume cs:code, ds:code
;
; Equates for controlling the ubnicps2 board
;
SCR equ byte ptr 0ffffh
SCR_GREEN equ 1
SCR_CA equ 2
SCR_LOOPBACK equ 4
SCR_RESET equ 8
;
; Data segment
;
public int_no
int_no db 3,0,0,0 ; interrupt number.
base_addr dw 0d000h,0 ; base segment for board (jumper set)
enet_addr db EADDR_LEN dup(?)
public driver_class, driver_type, driver_name, driver_function, parameter_list
driver_class db BLUEBOOK, IEEE8023, 0 ;from the packet spec
driver_type db 11 ;from the packet spec
driver_name db "NCR ET105",0 ;name of the driver.
driver_function db 2
parameter_list label byte
db 1 ;major rev of packet driver
db 9 ;minor rev of packet driver
db 14 ;length of parameter list
db EADDR_LEN ;length of MAC-layer address
dw GIANT ;MTU, including MAC headers
dw MAX_MULTICAST * EADDR_LEN ;buffer size of multicast addrs
dw 0 ;(# of back-to-back MTU rcvs) - 1
dw 0 ;(# of successive xmits) - 1
int_num dw 0 ;Interrupt # to hook for post-EOI
;processing, 0 == none,
enable_network:
; connect to network
push es
mov es,base_addr
or es:[SCR],SCR_LOOPBACK
pop es
ret
reset_586:
; Reset the chip
push es
mov es,base_addr
or es:[SCR],SCR_RESET
jmp $+2
jmp $+2
jmp $+2
jmp $+2
and es:[SCR],not SCR_RESET
pop es
ret
public get_address
get_address:
;get the address of the interface.
;enter with es:di -> place to get the address, cx = size of address buffer.
;exit with nc, cx = actual size of address, or cy if buffer not big enough.
assume ds:code
cmp cx,EADDR_LEN ;make sure that we have enough room.
jb get_address_2
mov cx,EADDR_LEN
mov si,offset enet_addr
rep movsb
mov cx,EADDR_LEN
clc
ret
get_address_2:
stc
ret
doca:
;we may be called from places in which ds is unknown.
assume ds:nothing
push es
mov es,base_addr
or es:[SCR],SCR_CA
and es:[SCR],not SCR_CA
xor es:[SCR],SCR_GREEN ;blink the led on each CA.
pop es
ret
assume ds:code
;yet, we really should assume ds==code for the rest of this stuff.
;
; Here we include the code that is common between 82586 implementations.
; Everything above this is resident.
include 82586.asm
; Everything below this is discarded upon installation.
public usage_msg
usage_msg db "usage: ncret105 [-n] [-d] [-w] <packet_int_no> <int_no> <base_addr> <Ethernet_address>",CR,LF,'$'
public copyright_msg
copyright_msg db "Packet driver for the NCR ET105, version ",'0'+(majver / 10),'0'+(majver mod 10),".",'0'+version,".",'0'+i82586_version,CR,LF
db "Portions Copyright 1988 The Board of Trustees of the University of Illinois",CR,LF,'$'
no_mem_msg db "No ET 105 found at ",'$'
no_eaddr_msg db "You must specify an Ethernet address for the ET 105",CR,LF
db "Your card came with a pre-printed label giving the address assigned",CR,LF
db "to this card.",CR,LF,'$'
check_board:
mov SCP,0 ;16-bit bus internally.
mov ax,base_addr
mov cx,4000h-1 ;test all 16K minus the SCR.
call memory_test
jz have_mem
pop dx ;drop our return address
mov di,offset base_addr
mov dx,offset no_mem_msg
call print_number
stc
ret
have_mem:
mov si,offset enet_addr
mov cx,EADDR_LEN
xor ah,ah
check_eaddr:
lodsb
or ah,al
loop check_eaddr
or ah,ah ;did we have all zeroes?
jne have_eaddr
pop dx ;return to the caller of etopen.
mov dx,offset no_eaddr_msg ;print this error first, though.
mov ah,9
int 21h
stc
ret
have_eaddr:
ret
public parse_args
parse_args:
mov di,offset int_no
call get_number
mov di,offset base_addr
call get_number
push ds
pop es
mov di,offset enet_addr
call get_eaddr
clc
ret
int_no_name db "Interrupt number ",'$'
base_addr_name db "Memory address ",'$'
public print_parameters
print_parameters:
mov di,offset int_no
mov dx,offset int_no_name
call print_number
mov ax,memory_begin
mov cl,4
shr ax,cl
add base_addr,ax
push ax
mov di,offset base_addr
mov dx,offset base_addr_name
call print_number
pop ax
sub base_addr,ax
ret
include memtest.asm
extrn get_hex: near
include getea.asm
code ends
end